[Galens]

Well, you would have to use EasyUO for this, as well as Razor.

When using the Razor application for hide, you would have it like this:


IF System message = You have been revealed (Or whatever it says)
Exec: Stealth (You want to use stealth as it trains both hiding and stealth)
End IF
(Check the LOOP box)
Hit Play

Here is a link to the Mining script for Easy UO. Now bear in mind, it uses a running script, meaning, you don't walk, you run. It will go all around the mine on its own, as well as, locate the forge, and smelt all your ores for you.


It does not however, bank your items. You must pause the EasyUO application, bank, then go back to a mine WITH a forge, hit play, and continue.

Here is the link to the script
http://www.easyuo.com/forum/viewtopic.ph...500#219500
Make sure you are download ZSMining script

Here is the link to the page holding the mining scripts
http://www.easyuo.com/psl.php?cat=45

Note: You will have to sign up, but it is very easy.

Note: If running a Vista Operating System, remember to run Easy UO with admin permissions. Instructions can be found here:
http://www.in-x.org/forums/showthread.ph...#post31187


Note: Do not start up UO with EasyUO, continue running it on Razor

Edit: if the "You have been revealed" method does not work.

I suggest setting it this way.

If System message = There is no more ore to mine(or similar to what you experience)
pause/wait 3000-7000 miliseconds (depending on how easy uo executes running to a new destination)
Exec: Stealth
End if
(Check the LOOP box)

This method will ensure that you stealth after the Easy Uo script is finished running to a destination, make sure you time it right.
You can have it stealth while running, because stealth has a timer delay, around 1-1.5 seconds. So being off a 1000 or two miliseconds for exec, won't hurt you. Experiment with it until you find a correct timing.