07-12-2008, 12:58 PM
Hey, I'm working on Cartography and I'm running into some annoying snags.
1) The blank maps, and the created maps all have the same ID.
2) The blank maps don't stack.
This makes stocking up on blanks and then macroing them overnight impossible. I've set up a macro that will buy 1 map from the vendor, craft it into a local map, then sell the local map, then repeat. This works out fine for the most part, but the only vendor I can find in britain only sells about 100 maps. >_<
Would it be possible for the number of maps on the cartography vendors to be increased to some large amount? Or perhaps change the display ID of blank maps and make them stackable?
1) The blank maps, and the created maps all have the same ID.
2) The blank maps don't stack.
This makes stocking up on blanks and then macroing them overnight impossible. I've set up a macro that will buy 1 map from the vendor, craft it into a local map, then sell the local map, then repeat. This works out fine for the most part, but the only vendor I can find in britain only sells about 100 maps. >_<
Would it be possible for the number of maps on the cartography vendors to be increased to some large amount? Or perhaps change the display ID of blank maps and make them stackable?
![[Image: 2cn76h2.gif]](http://i195.photobucket.com/albums/z169/DrMostaza/2cn76h2.gif)
![[Image: avatar20124_12.gif]](http://i195.photobucket.com/albums/z169/DrMostaza/avatar20124_12.gif){kind=avatar}
If you liked my posted, dont forget to thank me 
!
Much easier.